Short Shift Kit

After sorting out the issues with the gear lever and linkage I wanted to install a Short Shift Kit (also know as a Quickshift kit). The kit reduces the gear lever throw by 30%, making gear changes feel much tighter.

Several places sell the kit online but I went direct to Si Whitmore at T3volution who makes them. The kit only works with 14mm gear levers so check yours before buying. Generally:

• Vehicles up to chassis number WV2 ZZZ 25Z C 200 000 have a 12mm shaft
• Vehicles from chassis number WV2 ZZZ 25Z D 000 001 have a 14mm shaft

…but there was some crossover.

The guide below shows installation onto a T25 with petrol engine (diesels are slightly more complicated as you have to go under the van).

Note: Si is currently doing a deal on the kit for £20 including UK P&P if you email him direct.

The kit comes with detailed installation instructions and a handy diagram:

The first step is to unscrew the gear knob and pull the gaiter free.

Unscrew the gear nob

Pull off the gaiter

Next, slide the sleeve onto the gear lever and drill a recess with a 4mm drill bit (using the hole as a guide). Once done, remove the plastic sleeve again.

Note: I recommend covering the bush assembly before drilling, this will stop any metal filings dropping into it and ruining your nicely greased bushes.

Make a mark on the front of the assembly and the position of the bolts so you know which way to refit. Undo the locking collar and two nuts then slide the bush assembly off the gear lever.

Undo locking collar

Undo nuts and slide assembly off lever

Slide the plastic sleeve back onto the gear lever and screw the bolt extensions in place.

Put the spacer onto the bolt extensions (flat side up).

The last step is to slide the assembly back onto the gear lever, bolt it back into it’s original position and then secure the locking collar using your newly drilled indent.

The whole procedure took about 10 minutes to do.

With the kit installed the gear changes are so much nicer, i’d definitely recommend this upgrade if your gear linkages are in good order.